Hi everyone,
I need to connect two devices together. The advised form of connection is to use a USB A to serial (DB9 Male ) connector and then DB 9 male to DB9 female and then Rj11 connector. (Attached is the PDF shows the connections)
If the pins used in these conversions are VCC, D+, and D- why would having a direct USB to RJ11 might be a problem?
This should be more related to Control Forum.
I need to connect two devices together. The advised form of connection is to use a USB A to serial (DB9 Male ) connector and then DB 9 male to DB9 female and then Rj11 connector. (Attached is the PDF shows the connections)
If the pins used in these conversions are VCC, D+, and D- why would having a direct USB to RJ11 might be a problem?
This should be more related to Control Forum.
No comments:
Post a Comment